home  >  support  >  781
 

Find product   Documentation     Videos   and   Diagnostics  .

Documentation:

Videos:

Diagnostics:

This section contains fault-finding information, useful if the documentation and videos above haven't been able to help you. It is in two parts, first a short list of links to pages of common interest, e.g. Setting SBUS or Power Supplies, followed by specific details to help you with this product.

To fault find it is recommended that the problem is isolated to one area first. To do that use a standard servo, powered at 5volts, to check a PWM channel is working properly on the RC system. Without a known good servo signal available we cannot proceed.

With this known good signal applied to 1, and no camera connected, the double heartbeat should flash on the LED. If not check the servo lead and cabling between RC system and 1.

Connect the camera, the heartbeat should change to a single flash, and SHUTTER should trigger with moving the input channel. If not check the MULTI plug is fully pushed home, and that the camera is on our compatibility list.

If using PWM, continue by adding channels. If there are problems check each PWM channel with a standard servo before connecting to the camera controller.

If using SBUS did you use the programming guide in the manual (see link at top of page) to allocate SBUS channels to functions? It is extremely unlikely the factory defaults will work. Consult your RC system manual to understand what sticks and switches are available to use on SBUS.

If SBUS programming was successful, a single heartbeat is achieved, but operation gets no response? See the comment about SBUS convertors in the SBUS Set-up link above, you may need to disable error detection.

With the MULTI system, only one signal can be sent to the camera at a time, so return all servo inputs to idle when not in use. This stops repeated signals blocking the interface.

Some commands have longer reaction times (e.g. MOVIE) to prevent accidental activation. You may need to hold the control in place for a couple of seconds. Moving the camera from ON to standby takes up to 3 seconds for the same reasons.

Remember to return controls to idle after activation.

 

 

 

 

 

  Gentles Limited © 2013 web design by www.kb3d.co.uk